- This topic has 6 replies, 2 voices, and was last updated 13 years, 8 months ago by
.
-
Posts
-
12nc:851144015870
Water supply OK, fill valve OK.
Set to any programme and machine drains then stops dead, after a few seconds beeps and flashes 6 times.
Doesn’t have the doofer in the sump that usually gets gunged up, possibly flow meter/impellor but when these go it usually does try to fill for a short while, not had one totally dead due to flow meter.
Is that the most likely suspect, if so does anyone have the part number of the flow meter/fill chamber?
TIA.
Jim.
Re: Whirlpool D/W F06?
check that reed switch is sitting in right position and that connections are good.if reed switch is visable on this model then if can easily be replaced.
NiallRe: Whirlpool D/W F06?
Can you confirm that a faulty reed switch would give no fill at all, all the ones I have seen do at least attempt to fill for a second or so?
Re: Whirlpool D/W F06?
no cant confirm that but they are cheap so might be worth a go.
is the fill valve getting 230v? even for a split sec.
what type of pressure switch is in the sump.is it the usual mesh front or the newer pressostat?Re: Whirlpool D/W F06?
Doesn’t have the old type pressure switch in the sump. Just had a look in my garage and have a complete fill chamber assy, do you know if 481241868147 will fit this particular machine?
Jim.
- You must be logged in to reply to this topic.