Help Hotpoint WT960

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Help Hotpoint WT960

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 29, 2012 at 6:52 pm #70696
    davidjones125
    Participant

    My machine is about 3 years old every time I use my machine it blows the fuses about five minutes of the cycle.

    July 29, 2012 at 7:49 pm #378725
    Allsorts
    Participant

    Re: Help Hotpoint WT960

    Sounds like you may need a new heater
    http://www.ukwhitegoods.co.uk/search/fi … ineer.html

    July 30, 2012 at 7:24 pm #378726
    davidjones125
    Participant

    Re: Help Hotpoint WT960

    Had a repair man come out today was told Main PCB at fault I was told it Wasn’t blowing the fuse just switching itself off all the time.

    July 31, 2012 at 6:44 pm #378727
    davidjones125
    Participant

    Re: Help Hotpoint WT960

    I have been offered a WT965 with bearing failure Will the PCB from this machine fit My WT960.

    July 31, 2012 at 7:10 pm #378728
    iadom
    Moderator

    Re: Help Hotpoint WT960

    Not without reprogramming, for that you will need an Indesit engineer with his laptop, or you will have to purchase a £20 smart card and a £100 card reader to reprogramme the pcb.

    Just checked for you, some WT960’s do use the same PCB/Smartcard, it depends on which size of motor you have in it.
    You could always change over both the pcb and the motor. 😉

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.