Bissell 8910-E Aroma Pro Wet or Dry Upright Vacuum Cleaner

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bissell 8910-E Aroma Pro Wet or Dry Upright Vacuum Cleaner

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 17, 2012 at 2:46 pm #71007
    jontymox
    Participant

    Good afternoon all,

    Wonder if anyone can assist with a problem on the above m/c?

    The unit will not spray water through the two lower jets, but will do so through the flexible wand/hose.

    I have stripped the unit down, to check for blockages in the pipework, heater and jets.

    All clear, so renewed the pump which I felt may be weak.
    However, no change.

    Wondering if it is the switch/valve in the handle at fault, but would appreciate any feedback re: other known causes.

    Kind regards,

    jontymox

    August 20, 2012 at 12:24 pm #379619
    spanner51
    Participant

    Re: Bissell 8910-E Aroma Pro Wet or Dry Upright Vacuum Clean

    If its not a blocked heater, or the jets blocked, I would check that the piston in the smart valve is moving OK. If it is dislodged and fully down, that can cause your problem.

    August 21, 2012 at 3:41 pm #379620
    jontymox
    Participant

    Re: Bissell 8910-E Aroma Pro Wet or Dry Upright Vacuum Clean

    Thanks spanner51,

    Have had another look at m/c today, and checked piston/operation.

    This appears to be fine, and valve resistance suggests correct operation.

    Heater, pipework and jets all look to be in very good condition.

    I did clean the above last week.

    Wonder if their is an air lock, which is very difficult to ascertain, plus hose water delivery only sporadic too.

    Kind regards,

    Jon

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.