- This topic has 3 replies, 2 voices, and was last updated 13 years, 7 months ago by
.
-
Posts
-
I have now replaced the thermostats at the back – but it seems to be exactly the same…
If I bash it on the RHS panel at the top toward the front the orange light will flicker on – eventually with enough ‘gentle persuasion’ it will stay on and keep the heat on for the drying cycle.
It is getting worse and worse – as expected 😆
Is there another ovious place to look for a failure that might be overcome by repeated thumping?
Thanks for any help or bright ideas
Re: Hotpoint TDC60 – heat won’t stay on unless thumped!
Sounds liike a bad contact on the dryness module, likely to need a new pcb, rather expensive the last time I looked. 🙁
Re: Hotpoint TDC60 – heat won’t stay on unless thumped!
OK – thanks iadom – it’s useful to know if it’s basically come to the end of it’s life.
It is wearing out in other ways too – and has done a good many years service. So about time to say goodbye rather than messsing about too long with it.
Any particular recommendations for replacement? Would like condensor, silver/graphite and largish capacity at least 6kg…
Cheers
- You must be logged in to reply to this topic.