bosch srs43a02gb/08

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bosch srs43a02gb/08

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 22, 2012 at 5:01 pm #71091
    mikehha
    Participant

    hello all The cycle pump on this d/w is running slow,I have read in one of the topics that it could be 1 a blockage, but the motor turns freeley. 2 It could be the cap but this measures ok. any other suggestions please.

    August 22, 2012 at 7:41 pm #380029
    maltheviking
    Participant

    Re: bosch srs43a02gb/08

    How do you know the pump is running slowly?
    Is the water alternating between top and bottom spray arms, if not it could be the heater box/diverter valve. Is the wash pump impellor ok, can get damaged which slows down the water flow
    If the Cap was faulty the motor is unlikely to start and would just “buzz”

    August 23, 2012 at 7:12 am #380030
    mikehha
    Participant

    Re: bosch srs43a02gb/08

    how do I know its running slowly. well I removed the righthand side panel and I watched the back of the motor!

    August 23, 2012 at 10:00 am #380031
    Hollytree_Technical
    Participant

    Re: bosch srs43a02gb/08

    Have you taken the motor out?
    If it is running slow then it may be worth removing the motor and unscrewing the impeller off the end of the shaft so that you can gain access to see the front of the motor, it could be that you will find it covered in gunk and that the front bearing is rusty, if so then you will need to change the impeller seal and front bearing on the motor.

    Jem

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.