Dyson CR01 F11 Fault code

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Dyson CR01 F11 Fault code

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 24, 2012 at 9:03 am #71119
    Madmac
    Participant

    Rarely see these things but have a relative who inherited one in a house purchase, the 10A fuse on the board has blown, motors look ok with clean comms and barely worn brushes but didnt have my megger with me to test for leaks.
    I fitted a new fuse and ran the machine for a second on spin but was rewarded with a low growl and no motor action, switched it off before it blew the replacement fuse.

    I seem to recall something about the bridge rectifier on the panel giving this fault, anyone advise please ?

    Thanks,

    Eddie.

    August 28, 2012 at 11:52 am #380080
    electrofix
    Moderator

    Re: Dyson CR01 F11 Fault code

    if it blows fuse then bridge rec is likely

    take board out and check with multimeter

    cheap repair but board is a bit of a pig to get out and in again

    Dave

    September 4, 2012 at 8:17 pm #380081
    Madmac
    Participant

    Re: Dyson CR01 F11 Fault code

    Thanks Dave, might have a play with it on a quiet weekend 8)

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.