Whirlpool Washer/Dryer issues.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool Washer/Dryer issues.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 10, 2012 at 3:46 pm #71410
    iadom
    Moderator

    Model AWZ512/SE, 12nc..857594615000.

    Complaint of no drying. The TOC on top of the heater box had tripped, reset and it then ran fine, fan etc OK.
    Customer said she had done three loads in quick succession but as this is the first one of these I have seen ( what’s with those stupid long bolts holding the top on ) I just wondered if there are any know issues with the dryer side on these, condensor blockages or the like?

    Jim.

    September 10, 2012 at 6:57 pm #380974
    Mr Phil
    Participant

    Re: Whirlpool Washer/Dryer issues.

    A student landlord I do some work for, brought a job lot of these and really having seen 20 or so of them over the past few years. They are not bad W/D. No real issues with blockages the reset should have done the trick.

    Mr phul

    September 10, 2012 at 7:35 pm #380975
    HotDog
    Participant

    Re: Whirlpool Washer/Dryer issues.

    hi jim is the fan motor capacitor start had same fault on a bosch w/d turned out to be a faulty cap

    September 10, 2012 at 7:38 pm #380976
    iadom
    Moderator

    Re: Whirlpool Washer/Dryer issues.

    Hi Cliff, didn’t notice a capacitor, just a bog standard, shaded pole motor as far as I could see.

    Jim.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.