BEKO dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › BEKO dishwasher

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 9, 2012 at 1:30 pm #71871
    kevinlewis
    Participant

    i’ve searched under Beko dishwasher and did not get any results.Is this the first query or am i searching incorrectly?
    model DFN 1000X 2 YEARS OLD.
    no power getting to the waste pump.Fills and circulates okay.I’m suspecting the pcb but have not stripped the door to check for broken cables.any help appreciated.

    October 9, 2012 at 5:16 pm #382630
    Seamy
    Participant

    Re: BEKO dishwasher

    Model is correct.
    It gets its feed off KN3-7 on main board grey wire, neutral from KN2-1 motor board which is linked to other components & may need to be traced. It will also get a feed off float switch if water activates it, check float switch for burning, these have been prone to failure.

    October 10, 2012 at 9:46 am #382631
    kevinlewis
    Participant

    Re: BEKO dishwasher

    Thanks for your advice.I did not have time to strip the facia to check the pcb for loose connections or burn marks ect.
    would a fault on the float micro switch cause it to not pump out during normal operation? i did not see any signs of leakage on the bottom tray.
    can you give me the part number or price of new control pcb or the suppliers. Thanks.

    October 10, 2012 at 8:38 pm #382632
    Seamy
    Participant

    Re: BEKO dishwasher

    Part number for control p.c.b is 1733990415

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.