- This topic has 1 reply, 2 voices, and was last updated 13 years, 6 months ago by
.
-
Posts
-
hi,
i have the door locked light and light 3 and 4, ie, quickwash and 600/1200 spin, flashing at the end of a cycle, clothes un-spun. If i turn the machine off then on whatever setting i put it on after a 30 seconds water pumps out and water runs in and those lights start flashing. if i turn machine off, then on and just leave it the lights flash after 30 seconds, pump starts and water runs in. Is it terminal? 🙁
thanks.Re: hotpoint washer/dryer model no. BWD129
This machine has few, ii any redeeming features, it is 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} Indesit.
Lights 3+4 are F03 or NTC failure. If you are lucky this machine will have the earlier NTC ( Temp Sensor ) that is a round device located in the back of the drum, it has two wires attached to it and is secured inside a rubber grommet.
That type is prone to failure and is cheap to replace. If that part is not faulty then it could be bad wiring connections between the NTC and the main PCB or a failure of the main PCB itself.
Part number is C00053575.
Part available HERE
- You must be logged in to reply to this topic.