zanussi zwg1120m e62 fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi zwg1120m e62 fault

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 22, 2012 at 9:22 pm #72090
    larry
    Participant

    Just wondering if anyone has had this fault its a triac fault on the control board makes the motor run wild ,so i thought new board 200 quid or replace triac but i’m not sure which one it is there’s two on the board one on a big heat sink which i think is the one the other isn’t on a heat sink so perhaps this is a transistor of some sort would anyone know for sure if this is correct or not i’m a bit of a novice at electronics,Cheers Larry.

    October 23, 2012 at 6:50 am #383414
    Seamy
    Participant

    Re: zanussi zwg1120m e62 fault

    Have replaced dozens of the p.c.bs for e62s.
    You could trace the cable connections onto board & then via p.c.b track to the component. Hint :- J9 is motor & J12 tacho.

    October 23, 2012 at 7:11 am #383415
    captaincaveman1
    Participant

    Re: zanussi zwg1120m e62 fault

    E62 relates to a motor tacho fault so check this first and motor block connections before condeming the board

    October 24, 2012 at 5:53 pm #383416
    blackandwhites
    Participant

    Re: zanussi zwg1120m e62 fault

    Have seen quite a few. Loose tacho magnets on these machines

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.