- This topic has 6 replies, 4 voices, and was last updated 13 years, 5 months ago by
.
-
Posts
-
I need to remove the side panel to gain access to the connector plug to change the Heating elements but I cant get the top lid off, I have removed the 2 screws at the back of the lid in each corner expecting it to slide back and pull off but nothing.
It lifts from the back but feels like something is holding it in place at the front. I have looked but cant find any other screws, any help to remove the lid would be great.
Thanks.
Re: How do you remove the top of a Hotpoint tcm570p dryer
They can be very tight!
I usually remove tight tops using a rubber mallet, bang away at each front corner,..using short sharp blows…this usually shifts em!
Dont lift the front, just remove the rear screws…and proceed as described..
Hope it works for you!
Martin
Re: How do you remove the top of a Hotpoint tcm570p dryer
As above lid does slide to the rear as you expected but it will be tight. A good thump from your palm or from a rubber mallet should do the trick. It’s locked into the fascia aswell as either side panel.
Re: How do you remove the top of a Hotpoint tcm570p dryer
Thanks for the replies guys – going to tackle it now – Thanks for the help will post back in a bit. 🙂
Re: How do you remove the top of a Hotpoint tcm570p dryer
Worked a treat – Dryer element & thermostats replaced and like new.
That lid was tough though – It needed a good few knocks at the front for it to slide back. Thanks for the help, Much appreciated.
Re: How do you remove the top of a Hotpoint tcm570p dryer
People often look at me as if I’m mad when I’m smashing my hand against the front top trying to release it. Easiest way is a straight edge screwdriver between the metal back and lid and prise it back.
But more often than not its the palm.
- You must be logged in to reply to this topic.