Hotpoint BWM20

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint BWM20

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 16, 2012 at 9:13 pm #72566
    AJC_Dave
    Participant

    Went to one of these this evening with the customer reporting that the machine was dead. I replaced the motor brushes in it about 18 months ago and the way it has been installed means its a right fiasco getting it out.

    It lights up and locks but nothing else. I can get it out enough to check the brushes (which are fine) and the pump (again fine).

    I suspect the motor is at fault but was wondering if someone has come accross something similar on one of these as I’m not relishing the task of removing it to test if the customer doesn’t want to pay for a new motor.

    Any help is appreciated.

    Dave

    November 16, 2012 at 9:52 pm #384910
    Criscold
    Participant

    Re: Hotpoint BWM20

    Have you checked for broken wire on motor plug as this would also cause this

    Colin

    November 16, 2012 at 10:01 pm #384911
    AJC_Dave
    Participant

    Re: Hotpoint BWM20

    Hi Colin

    Had it tilted quite low but had a good look and feel back up the cables and all seemed good. However, I’ve missed broken cables plenty of times at first glance so its possible it could be. May have to pull it out eventually so will know better then.

    thanks

    Dave

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.