- This topic has 1 reply, 2 voices, and was last updated 13 years, 5 months ago by
.
-
Posts
-
I have a Hotpoint Ultima DWF61 which has been working fine for a while now, but I have started to have the following problem with it.
When I start a program off all seems to be going well and the timer counts down to zero from 2H so I think the cycle has finished, then when I open the door I find that it has not finished at all, then I shut the door and the timer shows 41 minutes again.
Any ideas what may be going on with it.
Thanks in advance.
Pippa
Re: Help with Hotpoint Ultima DWF61
It’s a Bosch based machine so decent kit.
It could be the pressure switch/level chamber, the metering tank or the transfer hose into the sump are badly clogged with gunge.
The can bee seen by removing the left hand ( from front ) side panel. after removing the mains plug of course.
- You must be logged in to reply to this topic.