- This topic has 4 replies, 3 voices, and was last updated 13 years, 4 months ago by
.
-
Posts
-
hi all finished one wash now wont go has error code 36 zanussi zwd1472s this is what i have done so far
disconnected wiring to black sensor with small pipe attatched disconnected white valve with other small pipe to it and i heard a click this is with all electric wires disconnected then pulling pipes off blown down each pipe whilst blowing block one pipe of and heard gurgling from each pipe disconnected all back up i can run drain program ok and wash program starts but then stops again after a minuite every time i disconnet the white valve it clicks and lets me restart machine any ideas what to do nextRe: zanussi zwd1472s error code 36 help
Most likely theres an earth fault on the dryer heater, power off, make a note of where each wire goes on the terminals, tape them to insulate them separately so they touch nothing. Try appliance on wash programme, if it goes o.k without putting up fault code order a new dryer heating element.
If this does’nt cure it E36 refers to a pressure switch fault, so either of the two pressure switches could be faulty, but its most likely an earth fault on dryer heater is giving eroneous error.
Re: zanussi zwd1472s error code 36 help
ok have now disconnected the heater element four wires and the wash cycle seems to work ok now should i try a new one of these
Re: zanussi zwd1472s error code 36 help
Think its one like this you’ll need..
- You must be logged in to reply to this topic.