- This topic has 3 replies, 2 voices, and was last updated 13 years, 2 months ago by
.
-
Posts
-
Has anyone got a manual for this or any info please.
The first call was that it wouldn’t finish the wash.
I found some stuff stuck in the pump and a slight leak from where the drain pipe fitting attaches to the sump, fixed those and away she went.
two weeks later, same problem.
had a look at all the obvious, no broken wires, motor good, element good, solenoid and px switch good, no obvious damage on the board, all pipework clear – worked twice then same problem, stopping during cycle with water in it.Now i have it opened up and on my work bench at home.
It’s on a quick wash and it has filled, heated, washed and emptied. Then went into a rinse and empty and now it’s filled, heated and is washing again!
This quick wash is now going on for 1 hour 30 mins…
Does anyone have a manual that has the wash schedule in it?
Or is the board just goosed?
The board is no longer available I’ve been told, so I can’t even order one.Cheers,
Dave.
Re: ZDT 6252 Dishwasher fault
Update.
Emptied hot water and then beeped 5 times.
Then after a few minutes, drying time i suppose, the machine filled up again and now the wash has finished with the end light flashing.
If this is normal for this machine then I’ve not noticed it before.
The customer has said in the past that it only gets about ten mins into the wash before it stops, I can’t get it to do that but should a quick wash take 1 hour 45 and then fill with water and stop?Re: ZDT 6252 Dishwasher fault
Dunno mate but here’s the manual if that helps?
- You must be logged in to reply to this topic.