- This topic has 1 reply, 2 voices, and was last updated 13 years, 2 months ago by
.
-
Posts
-
Miele G643 dishwasher. Select a wash eg No4 50 degree normal wash. Dishwasher will do the first part of wash and heat to 50 degrees and then pump out.It will fill for rinse and will wash for a couple of minutes before check intake/pump light starts to flash and dishwasher stops full of water. There are no blockages and on reseting program it will pump out. Has anyone come across this problem or know a remedy for fixing.
Re: Miele G643 dishwasher Intake/pump light flashing
Problems something arising with Miele d’washers are water in base activating float, flow meter sticking, circulation pump not getting full pressure because of blockage in impellors. The best thing for you to do is time the second fill, if it takes more than 4 mins to get the required amount of pulses from the flowmeter it will throw upinlet/drain fault.
This could just be a seating problem of the reed switch p.c.b not being able to pick up the impulses from magnet flow or as simple as a bad connection.
- You must be logged in to reply to this topic.