Hotpoint f10 error

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hotpoint f10 error

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 30, 2013 at 9:36 pm #73867
    humourbash
    Participant

    So far i had this washine machine.
    Drain blocked so freed it, heater element busted, so replaced that today.

    Now i get f-10 message with cold fill constant flowing and drain pump pumping same time. So turned it off, inspected heater element connections, they’re as it should be.

    Online shows cold fill blocked or waste kinked, (kinked? Whats that??) the machine was washing fine before i replaced heater element, only replaced cos online shown element fault if washing machine keeps washing on and on without drain and spin. The element i took out was ruined!

    Dont know whats up now. I wont do any testings but advice on whats wrong please?

    January 30, 2013 at 10:15 pm #389126
    humourbash
    Participant

    Re: Hotpoint f10 error

    Online showing pressure switch, to blow into the small pipe!

    If still dont work i’m gonna strip and sell for parts!!!

    January 30, 2013 at 10:21 pm #389127
    Martin
    Participant

    Re: Hotpoint f10 error

    humourbash wrote:If still dont work i’m gonna strip and sell for parts!!!

    That shows initiative…..go for it……..another bargain on eBay I shouldn’t wonder. 😀

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.