Hotpoint WMD960 – F10

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WMD960 – F10

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 31, 2013 at 8:29 pm #73886
    AJC_Dave
    Participant

    Got called to one of these that had a an F10 error 2 months ago. I cleaned the sump assembly which was bunged up and all has been fine since.

    Got called back to it today with the same fault. Sump is still clean so I changed the pressure switch and nipped up the pcb connectors. It now works until the door interlock is due to open at the end of the wash.

    Has anyone tried to reprogram the board to clear this as everthing seems to function ok on cycle. Was just a thought before I order a board.

    Thanks

    Dave

    January 31, 2013 at 10:33 pm #389191
    madangler1
    Participant

    Re: Hotpoint WMD960 – F10

    Don’t see f10 very often, its not detecting the pressure switch, its either going to be the harness or more likely a bad board. Doubt reprogramming will help this one

    February 1, 2013 at 12:05 am #389192
    AJC_Dave
    Participant

    Re: Hotpoint WMD960 – F10

    Thanks mate, appreciate the quick response. I’ve done couple with f10 but they have always had a welded drum and none older than a wml540. Usually a good clean out works but this one as you say looks like a replacement board. Thanks…Dave

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.