Bosch : Error E11 => NTC thermistor fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Bosch : Error E11 => NTC thermistor fault

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 3, 2013 at 10:22 pm #73936
    unixadmin
    Participant

    Hello world!
    I need “just a little help from my friend” 😀

    I have Bosch dishwasher model SMS50E02FF that never finish a program and stop with E11 error. I read your fault code page This error code can be caused by the thermistor or the wiring to it being faulty.

    I cannot found the location of NTC to check it.
    I only found one video but in my bosch model NTC is not located at the same place.
    http://www.repairclinic.com/PartDetail/ … 281/935369

    If you have a service guide or little help, it would be nice.
    regards,
    Joe Cocker 🙂

    February 4, 2013 at 8:28 am #389371
    Martin
    Participant

    Re: Bosch : Error E11 => NTC thermistor fault

    unixadmin wrote:I cannot found the location of NTC to check it.

    I’m not surprised you can’t “found” it as it is sneakily embedded into the heat pump heater coil. Sadly no service manual…….all the best! 😀

    February 5, 2013 at 11:35 am #389372
    unixadmin
    Participant

    Re: Bosch : Error E11 => NTC thermistor fault

    Hello Martin,
    Just a little question: where is the heat pump heater coil :clown:

    On a old bosch dishwasher is integreted on the bloc with circulation motor and pump but now impossible to locate, I upload a photo of my bloc, I disassembled the circulation motor. Can you explain me where is the NTC and heat resistor, please.

    thank’s in advance.
    Joe Cocker

    February 5, 2013 at 12:20 pm #389373
    Martin
    Participant

    Re: Bosch : Error E11 => NTC thermistor fault

    unixadmin wrote: Can you explain me where is the NTC and heat resistor, please.

    Right there attached to the main housing (7 terminal block – no’s 5, 6 & 7) 😀

    February 5, 2013 at 10:15 pm #389374
    unixadmin
    Participant

    Re: Bosch : Error E11 => NTC thermistor fault

    OK Martin!
    ——————————————
    Terminal:
    “1” ground
    “2” red
    “3” red
    “4” red
    Nothing ! hard to check without guide line.
    “5” + “6” = 10 ohms (up when heat it)
    “7” nothing
    ——————————————-
    What a pity that service manual for SMS series is not available on the international network :mrgreen: like “DISHWASHER SERVICE TRAINING MANUAL” … the perfect documentation for technician but related to SHU Series.

    Big up ! for Martin 💡

    one link for all other : http://www.cteq.ca/Doc_texte/Dishwasher … 0bosch.pdf

    bye.

    February 6, 2013 at 8:11 am #389375
    Martin
    Participant

    Re: Bosch : Error E11 => NTC thermistor fault

    unixadmin wrote:bye.

    Yeah, bye!….you take care now! :waving:

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.