BHWM129 flashing lights

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › BHWM129 flashing lights

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 4, 2013 at 6:03 pm #73954
    telemek
    Participant

    Can anyone help, I have a Hotpiont BHWM129UK/1/E built in washer which flashes 5 leds after about 5 secs from starting and does nothing else until power off.
    (leds are superwash,extra rinse,mini load,reduced creases & start/pause)
    any help would be appreciated. Thanks

    February 4, 2013 at 6:40 pm #389437
    HotDog
    Participant

    Re: BHWM129 flashing lights

    all light flash means there is a fault but it could be any thing start by check pump/door lock/motor/ brushes

    February 4, 2013 at 6:56 pm #389438
    telemek
    Participant

    Re: BHWM129 flashing lights

    Thanks, will check tomorrow.

    February 4, 2013 at 10:22 pm #389439
    HotDog
    Participant

    Re: BHWM129 flashing lights

    and dont forget to check capacitor on the board if its slightly raised thats the fault

    March 13, 2013 at 11:58 am #389440
    telemek
    Participant

    Re: BHWM129 flashing lights

    Checked all usual problems and all ok so changed PCB but fault remained, then replaced PCB tried to test pressure switch by blowing air into it and re-assembled and it worked ok, so could be pressure switch!

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.