Replacement PCB board on Neff dishwasher

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Replacement PCB board on Neff dishwasher

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 13, 2013 at 4:16 pm #74125
    ptaunton
    Participant

    I have just installed a replacement PCB board on my
    Neff Dishwasher – (Model No: S54M45X5GB/90) and am unable to change the model code, which is defaulted to C7.

    I have followed the instructions in the leaflet by holding 2 x buttons and turning on the main switch without
    any luck. The model code I require is either C3 or C8.

    Has anyone else experienced this problem?

    Paul

    February 13, 2013 at 4:34 pm #390083
    Martin
    Participant

    Re: Replacement PCB board on Neff dishwasher

    It can only be configured before locking it into place due to the fact that all the buttons aren’t accessible otherwise!

    February 14, 2013 at 8:48 pm #390084
    ptaunton
    Participant

    Re: Replacement PCB board on Neff dishwasher

    It’s a built in dish washer, and I was pressing the respective buttons before closing the door as per the instructions, but still no joy!!

    February 14, 2013 at 8:57 pm #390085
    Martin
    Participant

    Re: Replacement PCB board on Neff dishwasher

    You’ve misread what I said….have another read. 😉

    February 14, 2013 at 10:29 pm #390086
    ptaunton
    Participant

    Re: Replacement PCB board on Neff dishwasher

    Confused Martin! All buttons are accessible irrespective of whether the board is locked in place.

    The instructions say ‘hold 2 x buttons down and press main switch to increment model code’. Is this right?

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.