Candy GOFS-262 PCB controller?

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Candy GOFS-262 PCB controller?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 26, 2013 at 7:28 am #75201
    DeltaV101
    Participant

    Hi

    Anyone have any ideas where I could find a PCB controller module for a candy grand o GOFS-262s?
    Or even how to perform a reset on the existing one?

    I’m having a problem with the machines temperature at the moment, wasn’t heating so assumed it was the heating element until I ran a 90degree which worked fine.
    Checked the thermistor which reads about 17k ohms which looks ok (not short or open circuit) so that really leaves the PCB.

    Just having a problem sourcing it, any ideas ?

    Thanks

    Steve

    [attachment=1:3a3mbxzi]IMG_1714[1]__1366961037_92_239_141_246.jpg[/attachment:3a3mbxzi]

    [attachment=0:3a3mbxzi]IMG_1715[1]__1366961227_92_239_141_246.jpg[/attachment:3a3mbxzi]

    April 26, 2013 at 10:35 am #394202
    Specialist01269
    Participant

    Re: Candy GOFS-262 PCB controller?

    Hi Steve: What temerature did you check the thermister at ? Don’t assume that just because it shows resistance at 1 temperature it’s ok.
    Trace the tracks back form the heater connector on the board to the relay that switches it & try replacing that 1st, you may well find it cures your problem & it’s a lot cheaper than a new board.

    April 26, 2013 at 7:27 pm #394203
    helo_75
    Participant

    Re: Candy GOFS-262 PCB controller?

    thermister fault— five flashes…… id clean the selector with some switch cleaner and try it again first…

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.