- This topic has 4 replies, 4 voices, and was last updated 12 years, 11 months ago by
.
-
Posts
-
Hi Folks,
Machine set to run.
Does its initial drain – about 30 secs and then stops, no humming noise from fill valve and definitely not filling.
Drain pump kicks in again after about 20secs and again, goes on for about 30 secs. Machine continues to cycle in this manner.
No water in sump, no water leaked to the tray underneath, water supply to machine with good pressure.
I’m guessing possible pressure switch fault, or loose wiring at c board, or perhaps frayed wires at door hinge, although it’s only just out of warranty and doesn’t look to have been abused.
Any suggestions much appreciated
Re: Whirlpool int dishwasher ADG7470/1
you may get a better response by posting in the tech enquireies forum
Re: Whirlpool int dishwasher ADG7470/1
I too have the same issues, did anyone find out what’s wrong?
The dishwasher is 2 years old and just out of warranty. I did not test it thoroughly, no leaks, board is clean as whistle. The farmer’s wife says that is started off ok then stopped. I noticed the dishwasher tablet have not dissolved. I wouldn’t have thought the tablet drop out before the fill so the fill must have worked then prior to dispensing detergent. Just a thought, faulty detergent mech?
The farm has a history of power cuts but the dishwasher was not operating during the power cut. They have overhead electricity cable.
This dishwasher is on a working farm, I store my caravan there so I am hoping to secure some few months free storage in exchange of repair. So please help me here…
Matt
Sent from my iPad using Tapatalk
- You must be logged in to reply to this topic.