- This topic has 4 replies, 2 voices, and was last updated 12 years, 11 months ago by
.
-
Posts
-
Having problems calibrating the pressure switch on this machine after having to tip it back to clear a blockage in the sump hose. Have followed the reset instructions on previous posts and attempted about 20 times with no luck. Machine just pumps on all progs except 30 min wash where it does a bit of tumbling but no fill.Have checked voltage to pressure switch which is 5v as per markings on it. Any ideas/technical info greatly appreciated. Wiz
Re: Hotpoint Aqualtis AQ113D697S
Iv seen these get stuck in pump out after having f05, even after clearing the blockage it still just pumps. The only way I used to get around it was to reprogram the module.
Re: Hotpoint Aqualtis AQ113D697S
Thanks, don’t have the equipment required to do that and don’t do enough of these piles of crap to warrant the expense. I’m thinking that the pressure switch may by faulty & not returning to empty. Is there a set up procedure for a new switch other than the previously mentioned one ?
Re: Hotpoint Aqualtis AQ113D697S
No not really Its bloody odd when they do this, as iv said iv seen a fee in the past, it like the module gets stuck and wont move on past pumping. what could be worth a try is filling the drum with a good half of water, start a fast wash and let it pump and leave it until it either throws an error or starts as normal.
- You must be logged in to reply to this topic.