leaks

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › leaks

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 17, 2013 at 4:34 pm #75462
    okidokicoki
    Participant

    just a little question i changed the pump on my dishwasher and had a leak the clip i had was not fully stopping the leak , what is the best sealant to use if needed ????

    May 17, 2013 at 6:01 pm #394998
    Martin
    Participant

    Re: leaks

    We don’t use sealant on hose clips but rather use the correct clip (Jubilee type as a rule) and tension correctly.

    May 17, 2013 at 7:14 pm #394999
    okidokicoki
    Participant

    Re: leaks

    but if you did have to because i have over tightend clip and caused slight kink in plastic pipe that rubber hose fits over ,, yea im a numpty :boops:

    May 17, 2013 at 7:25 pm #395000
    Martin
    Participant

    Re: leaks

    Glue if you must then….take a trip to B & Q and buy a tube of Unibond or any suitable adhesive. We use Debor in the trade which is a bit like Evostik but far cheaper. You need to be over 21 to buy the stuff at B & Q mind you, and not look like a vagrant glue sniffer at the checkout. I get my Grandad to buy it for me on a Wednesday…….. 😈

    May 17, 2013 at 7:32 pm #395001
    okidokicoki
    Participant

    Re: leaks

    lol thanks for advice , i dont have a grandad to go for me so will have to chat up some old dear in there ,, very good reply made me chuckle 😆

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.