- This topic has 5 replies, 3 voices, and was last updated 12 years, 10 months ago by
.
-
Posts
-
12NC:859201315010
S/No:411112002597Display totally dead, good continuity into main pcb.
Customer says it is only a couple of years old, does this module suffer from the same faults that the Whirlpool boards did a few years back with a resistor failing?
Jim.
Re: Whirlpool AWOE9140 dead.
What was the outcome on this machine as I too have the same problem?
Board looks very clean, wondering if it’s the White capacitor box (12v doc 16a/250v) is the culprit?
Just that I had similar issue with a whirlpool dishwasher, summat to do with not powering up the PCB.
Re: Whirlpool AWOE9140 dead.
It’s a while ago now but I think the customer decided to buy a new machine.
Re: Whirlpool AWOE9140 dead.
you have to find the board power supply and see if you have got an output voltage.
if yes or if the voltage goes on and off its scrap new board need. if no power the board may be fixableDave
Re: Whirlpool AWOE9140 dead.
I brought the PCB home in the vain hope that I would be able to replace one of the box capacitor or voltage thingy, so how do you test it? (Edited this after googling – it’s the relay not capacitor that I was referring to.)
There’s no lights on the display and there is power going to the board but I do not know how to test it from the point of entry on the board to determine if there’s power or not.
- You must be logged in to reply to this topic.