Fisher & Paykel DD603

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Fisher & Paykel DD603

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 28, 2013 at 3:42 pm #75615
    nigegt
    Participant

    How does this model meter it’s water intake? Been to one today which fills fine but faults after so long with a no fill error code.


    Nige

    May 28, 2013 at 6:18 pm #395637
    johnmac11
    Participant

    Re: Fisher & Paykel DD603

    Hi Nigel,

    I assume you are getting a “U1” fault, if so it can be one of the following,

    The water supply is not turned on
    The machine is syphoning
    The spray arm is not in place
    Excessive foaming
    The Inlet Valve has failed
    The electronic controller has failed
    Rotor not fitted correctly

    The fill level is decided by the resistance of the rotor motor which has a magnet embedded into it and a hall sensor below the main motor, firstly check that the rotor motor is turning freely and that the contacts on the hall sensor are not corroded as these are the two common faults.

    John

    May 30, 2013 at 7:35 am #395638
    nigegt
    Participant

    Re: Fisher & Paykel DD603

    Brill thanks John! Corroded plug connector contacts cleaned up and runs a treat (Every day is a school day!)

    Nige

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.