Whirlpool JT366 microwave

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool JT366 microwave

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 7, 2013 at 8:35 am #75758
    Muv
    Participant

    Hi

    Has anyone got any service info on these machines…need to get at the magnetron to replace it, but cannot see how to remove it!

    Thanks
    Martin

    June 7, 2013 at 9:11 am #396045
    admin
    Keymaster

    Re: Whirlpool JT366 microwave

    Hi Martin

    Easy when you know how 😉 you need to remove all the rear screws including the rear fan cover and you will find 3 screws at the bottom undo those and then put the fan cover back on. tip it on its back and remove the 2 skid feet and then remove the front bottom trim and you’ll find a couple more screws. the base will then come off.. :eeek: there is a black wire to the relay that is tight so will need to be disconnected as is a multi plug rear left and front left.
    The base then can be laid down. the black duct is secured by ONE screw one the side T20 torx secures the mag into place.

    Reassembly by reverse :clown:

    Bryan

    June 7, 2013 at 9:31 am #396046
    Muv
    Participant

    Re: Whirlpool JT366 microwave

    Hi bryan

    I have got as far as removing the top by taking all the rear screws from the top and aslo the four hidden screws revealed after removing the skid feet, then i noticed at the screws that seemed to be holding the magnatron were inside the oven itself around the wave guide covers…it was at this point i gave up!

    I will follow your info and see how i get on with that!

    Thanks
    Martin

    June 17, 2013 at 12:59 pm #396047
    Muv
    Participant

    Re: Whirlpool JT366 microwave

    Anyone know where i can lay my hands on a new magnetron for this machine…everywhere seems out of stock!

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.