- This topic has 7 replies, 4 voices, and was last updated 12 years, 9 months ago by
.
-
Posts
-
hi,
the dryer runs for about 5 mins then it cuts out/goes dead
all thelights go off.
if i turn the dial to off and wait a minute before turning it back on it goes again.
I replaced the ntc probe behind the front bottom panel but it made no difference,
there is a small square pcb on the side panel with 2 big clear relays. I think it may be faulty but although it shows it on bosch website parts diagram it has no part n.
Anyone got a part no. for this part.sorry posted in wrong forum.
Re: bosch WTE84107GB/02 dryer
Unlikely to be that board. That’s a starting relay. If the socket is all ok , the more likely culprit is the control module – 499428 – and it’s not cheap !
Re: bosch WTE84107GB/02 dryer
That’s too bad I was hoping it would be the relay board. Thanks for the reply.
Re: bosch WTE84107GB/02 dryer
Have a good look at all the solder joints on the board otherwise it may be the switch mode chip causing it.
Jem
Re: bosch WTE84107GB/02 dryer
Sound just like the fault I had with WTE86304GB/05 which was the switch mode IC which you can get from CPC. See my posts for this Model
Re: bosch WTE84107GB/02 dryer
The IC was a TNY266PN which is on the main pcb on the WTE86304, worth a check to see if its the same IC on the WTE84107GB.
- You must be logged in to reply to this topic.