hotpoint washing machine wf620 fault

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › hotpoint washing machine wf620 fault

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 24, 2013 at 5:27 pm #75981
    arky1st
    Participant

    After approx 1 minute display reads end and f08 have replaced module and heater assembly any ideas??

    June 24, 2013 at 5:50 pm #396845
    iadom
    Moderator

    Re: hotpoint washing machine wf620 fault

    arky1st wrote: have replaced module and heater assembly any ideas??

    Replace the machine, :rolls:

    F08 can be a very difficult fault to cure, that is why I will not even attend a machine with F08 these days, been out of pocket far to many times. 😥

    Could be pressure switch, faulty wiring, module, heater, ntc. Indesit electronics are some of the most unreliable on the market TBH.

    Was it a new module?

    February 26, 2014 at 12:23 pm #396846
    A1applianceservice
    Participant

    Re: hotpoint washing machine wf620 fault

    We went out to a Hotpoint WF860P washer with F08. Fitted a new element and NTC sensor, still same fault. After reading this, sounds like advising the customer to buy a new machine…

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.