hi all this machine is letting water into the base via a plastic moulded tube on the bottom of the machine it looks like the gutter runs along the edge and into a series of passages into this tube and into the baser causing the float to be activated any ideas why this is happening the seal along the bottom of ther door looks ok
The water can only come from the compartment that they come from. Is the inside of the DW filling whilst not used ? Check that the waste is higher than the sink trap or try turning off the water when not used to see if the valve is seeping
ive been to another one of these , same fault replaced door seal at bottom and surround , still letting lots of water into the gutter at the bottom of door and onto the floor! this is obviously design fault someone must have come across this b4 no?