- This topic has 0 replies, 1 voice, and was last updated 12 years, 9 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Customer reported that machine stopped with 1 minute left. I tested on spin and found that it tumbles fine, but as it starts to spin it “coughs and splutters ” just like worn brushes and never reaches any speed. As it’s a brushless motor and the motor tests ok and doesn’t seem to overheat, it points to the motor control board. I just wondered if anyone has had a similar fault.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.