- This topic has 4 replies, 2 voices, and was last updated 12 years, 8 months ago by
.
-
Posts
-
Have collected a Miele T-430 tumble dryer for repair as there is no heating when running. The heating element reads around 19 ohms so that looks ok but there are two temp cut outs on the back plate by the heater?
The two spade connection item 1F1 is completely blown and the markings have gone to its type and temp range but the three spade connection item 2F1 looks ok.
Does anybody know the temp range of the straight TOD-G1 that has burnt completely out and the connection is hanging off it?Also most web sites show the three connection type but not the two connector one which is blown. Any Miele spares out there?
Thanks chaps for any help. Nothing shown on the circuit diagram to type.FlyingBrick
Re: Miele Novotronic T430 thermostat cut out blown
ring miele themselves
part are not cheap but they will often give you the part number and you can search around but most times i just order and charge it on
Dave
Re: Miele Novotronic T430 thermostat cut out blown
Thanks electrofix
Will ring them tomorrow for crazy prices.
Used to get cheap parts from a Danish business operating from a farm building on an Island which were about 30-38{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} cheaper but suspect Miele put them out of the game a few years ago.FlyingBrick
- You must be logged in to reply to this topic.