- This topic has 0 replies, 1 voice, and was last updated 12 years, 8 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Went to this dishwasher today, fault was 1 min left in display and not emptying water at end of cycle.
On testing, machine kept cutting out, display going blank.
So checked power supply and found burnt out pin on 13 amp plug, replaced plug
and fed plug to different socket & tested- all OK, but display still shows 1 in display at end & programme countdown not displayed at all.
Could the power interruption cause the display pcb to play up, ie not register the correct setting.
Is there a way to set machine back back to default, other than the reset cycle?Clive.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.