- This topic has 8 replies, 2 voices, and was last updated 12 years, 8 months ago by
.
-
Posts
-
Enr:S5453X-GB/74.
Customer just phoned with this so not been out to it yet.
Apparently fully integrated, when switched on any programme, pump runs for a few seconds and then machine cuts out, no lights appear on display at any time .
Any thoughts?
Jim.
Re: Neff dishwasher, no lights on?
I’m pretty sure the Control module (00641159) is the main suspect here.
Re: Neff dishwasher, no lights on?
Thanks Martin, looking at it on Thursday, are there likely to be any obvious signs of damage ?
Jim.
Re: Neff dishwasher, no lights on?
Actually Jim from ones I have changed they don’t always show signs of damage as a rule. Hopefully yours will be burnt to a crisp and obvious…..fingers crossed!
Re: Neff dishwasher, no lights on?
Blown triac on pcb, its the far left, horizontal one.
Anyone any idea what this triac controls?
Jim.
Re: Neff dishwasher, no lights on?
Looks like it goes direct to the two pin connection directly below so my guess is that it’s probably leads to the dispenser solenoid whatyamathingy?
Re: Neff dishwasher, no lights on?
Hmm, better than it being the water heater assy I suppose. 🙂
Are the dispensers prone to blowing triacs on these?
Re: Neff dishwasher, no lights on?
iadom wrote:Are the dispensers prone to blowing triacs on these?
Not uncommon for sure.
Re: Neff dishwasher, no lights on?
Changed dispenser and pcb today, all is now fine.
One question though, the replacement dispenser 490472 did not have the same connectors as the original.
There is a connector to the bottom left of the old dispenser which I assume is for the low rinse aid indicator.
I fitted the new dispenser and taped the surplus plug safely, as customer uses Finish 5 -1 tablets anyway I am guessing/hoping that this will not be a problem. 🙂
Jim.
- You must be logged in to reply to this topic.