- This topic has 5 replies, 3 voices, and was last updated 12 years, 7 months ago by
.
-
Posts
-
Hi, I have a hotpoint hvl211 washing machine and it will go through the wash fine, but when it goes onto start the rinse it stops doing anything, it sounds like its pumping water out and it starts flashing superwash and door locked, if I wait for it to stop making the noise I can then turn it off and start it to rinse and spin, it will then rinse but as soon as it tries to start to spin it has a little try then stops and the same lights start flashing again. Any ideas what could be causing this? Any help will be greatly appriciated!
Re: Hotpoint HVL211 not spinning
How many times has this happened, have you tried with an empty machine to see if its ok then
Sent from my iPad using Tapatalk HDRe: Hotpoint HVL211 not spinning
It was doing it all yesterday, everytime I tried, this morning I tried again and it worked fine, then I tried again and it stopped working again. I’ve tried it with a full load, empty, half load all sorts and it just does the same thing. I’ve tried a good 15/20 times
Re: Hotpoint HVL211 not spinning
You could check the obvious like the filter, possibly a blockage
Sent from my iPad using Tapatalk HDRe: Hotpoint HVL211 not spinning
Yeah I forgot to mention, I have already checked the filter and cleaned it as much as I can in there but it does still do it
Re: Hotpoint HVL211 not spinning
Kayloo wrote:Yeah I forgot to mention, I have already checked the filter and cleaned it as much as I can in there but it does still do it
any water left in the drum? if not drain pump doing it’s job…check motor brushes also resistance reading on inlet coil/valve should read approx4kohms if you’r in a hard water area check wash heater±wash ntc should read approx 30ohms for heater and 20kohms for ntc.hope this helps.take care.keep safe.
- You must be logged in to reply to this topic.