- This topic has 4 replies, 2 voices, and was last updated 12 years, 7 months ago by
.
-
Posts
-
Got any advise anybody on this fault with a hotpoint wf321 model code 31167 ,set machine to wash programme will fill with water and attempt to spin and then the rinse hold light will flash and on/off switch will flash very quickly then water is pumped out ,by the way this is a split drum and bearings need replacing any body know what size they are before i attempt repair thanks
Re: Hotpoint wf321 model code 31167r
Have you bothered to look at the Known Error Codes thread?
You need to check those numbers or this machine could be a ‘cut and shut’ job.
WF321 only has a sealed drum and that commercial code is for a WF000P. 😕
The WF000 can have either 30 or 35 mm drum shaft & bearings.
Re: Hotpoint wf321 model code 31167r
If this site was easier to navigate to the error codes listing i would have looked but as it is !! yes think this machine has been a “cut and shut job” door sticker says wf000 and it has split drum with 30mm bearings but front facia is wf321 !
Re: Hotpoint wf321 model code 31167r
mjw1208 wrote:If this site was easier to navigate to the error codes listing i would have looked
The error codes thread has been compiled over many years by several members taking their precious time and effort to add codes whenever they become available.
The thread is a sticky at the top of the Trade Technical forum, how hard is that to find?
If you cannot be bothered to take a few minutes of your time to look through it then that is your loss. :rolls:
- You must be logged in to reply to this topic.