Bosch SMV53A00GB/01

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch SMV53A00GB/01

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 12, 2013 at 5:07 pm #77110
    Criscold
    Participant

    I have called at the above Bosch dw that was giving an error E15. water in base and anti flood activated. It appears that the machine is leaking from the rear RH corner and looks like the seal between base & SS liner as water marks coming down the inside of the base. Looking at diagrams no seal is listed there, I have never had the pleasure of dismantling the newer type Bosch dishwashers and would appreciate any advise that anyone could offer.

    Many thanks

    Colin

    September 14, 2013 at 5:41 pm #401049
    Criscold
    Participant

    Re: Bosch SMV53A00GB/01

    Nobody Knows how 🙁 🙁

    September 16, 2013 at 6:54 pm #401050
    smeghead
    Participant

    Re: Bosch SMV53A00GB/01

    Hiya,
    Just saw your post tonite, had same problem with a Neff dw today.
    I posted earlier with no response so far- cant believe they don’t fit a seal between tub and base. Maybe they use a mastic not visible .
    I used to recommend bosch and Neff, not sure there any good now.

    Clive.

    September 16, 2013 at 8:56 pm #401051
    rocker
    Participant

    Re: Bosch SMV53A00GB/01

    just repairing a siemens new type d/w. you have to buy a new sump if there is a leak, about £40.00 john

    September 17, 2013 at 5:57 pm #401052
    Criscold
    Participant

    Re: Bosch SMV53A00GB/01

    Looking at the listing on the Bosch site It appears that no sump is available for this model, I see that it is a common problem. This machine is only about 18 months old and installed in a small estate of about 30 houses. I understand that they all have the same appliances fitted and looks like they are not Repairable ??

    September 17, 2013 at 6:01 pm #401053
    Martin
    Participant

    Re: Bosch SMV53A00GB/01

    Quite correct Colin, not available, don’t know of a solution either. Cabinet distortion/ poor installation may be the cause if the appliance has been seriously unlevel I’m thinking. BER ???

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.