Hoover HNV375 Sensor Plus intermittent reverting to start

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HNV375 Sensor Plus intermittent reverting to start

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 20, 2013 at 2:59 pm #77242
    Washdisher
    Participant

    Only have customer’s word for this.

    Set to timed. Heats and rotates fine but then stops after a period of time (anywhere from 20 mins to 2 mins), the ‘time remaining’ neon goes out and the ‘start’ neon goes on. It will start again immediately but then only run for about 2 mins. I observed it today and it didn’t put a foot wrong during the approx 10 mins I was there. Have asked customer to try it on a sensor prog and report back. Filter and duct were clean and no warning lights such as ‘check filter’ were illuminated. Any ideas?

    September 25, 2013 at 9:04 pm #401519
    Washdisher
    Participant

    Re: Hoover HNV375 Sensor Plus intermittent reverting to star

    Customer reports it works ok on sensor settings. Conclude therefore that it’s a timer fault on the PCB

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.