Miele W504 heater element

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele W504 heater element

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 26, 2013 at 8:59 am #77340
    pegasusk7
    Participant

    Never got involved with Miele before so what’s involved with replacing the element, doesn’t look like the traditional single nut fitting?!

    Phil

    September 26, 2013 at 11:05 am #401888
    Muv
    Participant

    Re: Miele W504 heater element

    They are just held in place by the gold coloured locking washers, that you see up against the rubber seal, if you dont have replacement washers with the new element then be careful when you remove them, once you have them off its just the usual bit of brute force to remove the seal..
    Also make sure you locate the front of the element correctly inside the lower drum holding plate…

    M


    Martin

    September 26, 2013 at 12:41 pm #401889
    pegasusk7
    Participant

    Re: Miele W504 heater element

    Cheers Martin,

    So leaks aren’t particularly an issue?

    Phil

    September 26, 2013 at 2:33 pm #401890
    Muv
    Participant

    Re: Miele W504 heater element

    No, as long as you get the seal located properly you shouldnt have a problem.


    Martin

    September 26, 2013 at 4:22 pm #401891
    Seamy
    Participant

    Re: Miele W504 heater element

    Amazing that they don’t leak very much when you consider its just a push fit, every other appliance needs a right spannering to get them leak free.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.