Asko 20004 Washing Machine

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Asko 20004 Washing Machine

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 17, 2013 at 5:43 pm #77669
    mendy
    Participant

    Hi All Anyone got any info on this classic have repaired control board but forgot how you program these to fill only on cold.I used to know its just a matter of pressing a couple of button.
    Regards

    October 17, 2013 at 5:47 pm #402998
    Martin
    Participant

    Re: Asko 20004 Washing Machine

    Wrong forum.:rolls:

    October 17, 2013 at 6:27 pm #402999
    iadom
    Moderator

    Re: Asko 20004 Washing Machine

    Moved, this is not a general trade question.

    October 17, 2013 at 10:34 pm #403000
    eastlmark
    Moderator

    Re: Asko 20004 Washing Machine

    need the “wm??? model number but the usual one is this:

    5. Fit an electrical jumper between the new inlet
    valve and the 3-way valve, see the electrical
    schematic diagram.
    6. Install a new wire from IV3 to the programmer
    header connector E4-3, see the electrical
    schematic diagram.
    7. Reprogram the program controller. Press the
    Enter button 5 times and then the P4 button
    5 times. Within the next 3 seconds press one
    of the following buttons to make your choice:
    arrow left: Cold water (C shown on the display)
    arrow right: Hot water (H shown on the display)
    Enter: Mixed supply (E shown on the display)
    3 seconds after the last button press, the program
    will return to its original state.

    October 18, 2013 at 10:17 am #403001
    spanner51
    Participant

    Re: Asko 20004 Washing Machine

    Phew
    Why not just fit a Y piece on the cold tap?

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.