Bosch wae24162gb/03 – no spin

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch wae24162gb/03 – no spin

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 14, 2013 at 9:42 am #78101
    gadgetdad
    Participant

    Hi guys, got one of these in the workshop had blown tracks on the power board from the commutator I believe. Have had the motor checked and is fine, have repaired the tracks on the board and put it back together.

    Putting it on spin to test, pump runs, motor turns over briefly as it should to stir the clothes for a couple of times, but then it just stops and sits there – anything else I should check on the board, assuming the motor is good.

    cheers

    gadget

    November 14, 2013 at 10:02 am #404463
    Martin
    Participant

    Re: Bosch wae24162gb/03 – no spin

    The PCB I think is detecting an unbalanced load (fuzzy logic circuit) no doubt in spite of no load being in there. So I reckon the PCB is duff as a blown track on it has most likely corrupted the EEPROM.

    November 14, 2013 at 11:03 am #404464
    gadgetdad
    Participant

    Re: Bosch wae24162gb/03 – no spin

    Hi Martin thanks for the reply. Do you mean on the power board or the control module – assuming you mean the power board.

    cheers

    gadget

    November 14, 2013 at 1:17 pm #404465
    Martin
    Participant

    Re: Bosch wae24162gb/03 – no spin

    gadgetdad wrote:Do you mean on the power board or the control module

    Yes I refer of course to what you refer to as the “power board” rather than the programme selector module. 😀

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.