- This topic has 2 replies, 1 voice, and was last updated 12 years, 5 months ago by
.
-
Posts
-
I hope someone can help. I have an integrated Belling SGE 12X washer-dryer. Been working great, only ever light use (in fact we only ever use washing machine), never had any problems till last time my wife used it, when it was finishing the wash cycle in the final fast spin and we heard a loud bang. Luckily as it was near end of final spin the drum had already drained and we could just turn off then open door and take out the washing.
Had a quick look and set it empty just to spin cycle on the dial, starts up ok turning at slow speed/low gear, then just trips and does accelerate and the dial just starts turning also GET 3 Flashes on red light. Any ideas as to what fault could be?
Thanks in advance for any help.Re: Belling SGE12x (uk) integrated washer/dryer 3 flashes
PS, I believe after reading around that Belling may just re-badge these and it’s identical to an Indesit wd12x.
By the way, the Belling SGE12x washer dryer is integrated/built in and has a matching unit door and front plinth attached that has to be removed prior to trying to edge it out from under the counter. I am disabled and my wife and I my not be able to pull it out. I believe the fixed fee repair Companies like repaircare etc will not do this and expect the appliance to be pulled out completely or will not touch it.
Any advice will be really appreciated.Re: Belling SGE12x (uk) integrated washer/dryer 3 flashes
sorry my original post has a typo…..should read…..
” Had a quick look and set it empty just to spin cycle on the dial, drum starts up ok turning at slow speed/low gear for about 10 seconds, then just trips and does NOT accelerate to faster speed and the control dial just starts turning also GET 3 Flashes on red light”. Any ideas as to what fault could be?
Thanks in advance for any help.
- You must be logged in to reply to this topic.