- This topic has 6 replies, 3 voices, and was last updated 12 years, 4 months ago by
.
-
Posts
-
Help please. Got one of these Hoover t/dryers that is not starting- i.e. the drum`s not going round. Only thing that seems to work is the condenser pump! Door m/swt ok, had a look at the pcb which visually seems ok but I have my doubts based on not a lot! Any one had this problem before? Thanks.
Re: hoover t/dryer vhc392t-80
Occurred to me too but not humming and the drum does not move when flipped by hand from under the lid- it would if the cap had gone.
Re: hoover t/dryer vhc392t-80
Dunno TBH what I can do to help other than send you the test sheet. Email me if you want one (remind me of model etc if you do).
Re: hoover t/dryer vhc392t-80
Looking at the circuit diagram on Connect I would suggest checking out the pressure switch – it should have continuity between 1 and 2 on the switch (if it is awkward to access then try checking for continuity between pins 1 and 3 on the 5 pin connector to the board). It looks like the live feed for the motor and heater are through this switch.
Jem
Re: hoover t/dryer vhc392t-80
Thanks Martin and Jem, will contact you when I go back- but just been told that the customers are off for a week anyway. Think I`ll order the pcb and see what happens when I go back, seems like a similar senario to how the boards went wrong on Hoovers previous efforts.
- You must be logged in to reply to this topic.