- This topic has 1 reply, 2 voices, and was last updated 12 years, 4 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hi, working on a WT945 Miele washer dryer where the clothes dry ok but before it goes into the cool down cycle, the dryer overload lamp comes on..and it is NOT overloaded…
Any ideas on this one?..
Thanks
PaulRe: Miele WT945 dryer overload fault
Theres a load sensor on the little shock-like leg which measures weight, check its moving up & down o.k & cabling to it.
Dryer load should normally only be about 3kgs as far as I can remember, normally 1/2 a wash load.
Think the load sensor can be calibrated in settings, it actually tells you how to do this in user manual.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.