- This topic has 10 replies, 3 voices, and was last updated 12 years, 4 months ago by
.
-
Posts
-
HI
i had the module tested on this and it came back ok however it still faults, it was suggested the pressure switch can cause this, does any one know if thats so, also can anything else cause this fault.
thanks John
Re: WF240 LIGHTS 2,3,4
Sigh..moved to correct forum. This is not a General Trade question.
According to the manual,
Heater relay stuck: check heater and module
connectionsRe: WF240 LIGHTS 2,3,4
Posted in wrong forum :lesson:
2,3 & 4 according to the KNOWN ERROR CODES IN TRADE TECHNICAL = Heater Relay fault.
Re: WF240 LIGHTS 2,3,4
hi thanks i posted this question in trade technical enquiries is that wrong ?
Re: WF240 LIGHTS 2,3,4
delta01 wrote:hi thanks i posted this question in trade technical enquiries is that wrong ?
You posted it in General Trade, Jim moved it to the correct forum.
Re: WF240 LIGHTS 2,3,4
not so it shows on my list of posts as being in trade technical, any way i’m not going to nit pick
Re: WF240 LIGHTS 2,3,4
As you say, not worth nit picking about however you did post it in the General Trade forum. I moved it to Trade Technical as I said in my first post.
Not sure which list you have but here is a screen shot of the moderator logs for that day.
You will see that the time of the thread I moved coincides with my post in your thread. 😉
Re: WF240 LIGHTS 2,3,4
WF240 LIGHTS 2,3,4
by delta01 » Fri Dec 06, 2013 4:19 pm in Trade Technical Enquiries
8
39
by iadom
Sun Dec 08, 2013 9:22 amRe: WF240 LIGHTS 2,3,4
That is the time you posted the thread in the wrong forum, the moderator logs clearly show that I moved it from the General Trade forum to the Trade Technical forum and then posted my reply 2 minutes after moving it. 😉
No one can alter the logs, they are a record of all moderator and admin activity.
- You must be logged in to reply to this topic.