Upper wash arm dodgy connection?

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Upper wash arm dodgy connection?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 13, 2013 at 9:21 pm #78608
    Wilki2013
    Participant

    Hi,
    I have a hotpoint BCI450 and after the last wash it appeared that the upper basket items were still slightly dirty. It has performed flawlessly up until now.

    I checked the arm wasn’t blocked and could rotate freely, however on closer inspection it appears that where the arm (its feed pipe) connects into the back of the dishwasher when you push the basket back is rather loose. Should there be some kind of seal or o-ring to receive the spigot from the spray arm assembly. I seem to remember that this has always been a snug fit.

    If so, would anyone know the part number (or size if its just an o-ring!)

    Many thanks,
    Ian

    December 14, 2013 at 5:51 pm #406246
    Dave_Conway
    Participant

    Re: Upper wash arm dodgy connection?

    Hi Ian,

    Is it this you need:

    http://shop.ukwhitegoods.co.uk/c0005486 … g-nut-seal

    Normally the seal in the nut is the problem 🙂

    Dave

    December 21, 2013 at 3:18 pm #406247
    Wilki2013
    Participant

    Re: Upper wash arm dodgy connection?

    Perfect, thank you.

    Just unscrewed and the seal is perished and split, should have done this first :boops:

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.