Whirlpool ADG7560

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool ADG7560

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 19, 2013 at 3:11 pm #78692
    plattste
    Participant

    I have a whirlpool dishwasher – it runs fine through the cycle for say 45 mins and then you here it constantly beeping ( maybe 5 beeps) and you can hear water draining away – It seems like the heating part of the machine has gone ???
    I had KNowHow who dont know how – they diagnosed it and said it was the PCB board – they replaced it and does the same thing – is there anyhing I can check ??

    I work in IT so bit handy with PC’s

    It seems to get stuck and wont go any further

    any ideas Xmas is coming ??

    Thanks Steve

    December 20, 2013 at 7:59 am #406587
    nigegt
    Participant

    Re: Whirlpool ADG7560

    When the dishwasher faults the start led will flash a number of times to give a fault code. There will be so many flashes and a one second gap then it repeats. Three flashes is a heat fault.

    A good place to start first is the wiring in the door where it comes through from the base up to the module. Often it is the heater wire that breaks.

    Nige

    December 20, 2013 at 9:17 am #406588
    plattste
    Participant

    Re: Whirlpool ADG7560

    OK I will have a quick check tonight I take it I will have to take the front of somewhere !

    Cheers Steve

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.