- This topic has 2 replies, 2 voices, and was last updated 12 years, 3 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
customer tells me the machine starts it takes in small amount of water then goes dead( No error code) !! same thing if set on spin starts runs for short run then goes dead, has to keep resetting to start again. !!
any advice as to possible cause would be welcome. please John.Re: zanussi ZWD1272W
Disconnect the leads going to dryer heater, isolate(tape up). Try machine then to see if it works.
Test heater on dryer side for low resistance to earth, has been known to cause the aforementioned & many other problems.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.