HOTPOINT WT960

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › HOTPOINT WT960

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 27, 2013 at 2:32 pm #78755
    bill0606
    Participant

    Hi my HotpointWT960 STARTS TO FILL THEN STOPS AFTER ABOUT 15 SECONDS THEN JUST COUNTS DOWN THEN DRAINS THE WATER AT END OF CYCLE PLEASE HELP when left for about 5 minutes f.18 starts to flash

    December 27, 2013 at 2:55 pm #406791
    iadom
    Moderator

    Re: HOTPOINT WT960

    Are you getting any error messages in the display?

    Most actual faults with the exception of a faulty heater will throw up an error code.

    If there are no error codes shown then there is no obvious cause.

    You have to remove the mains plug and visually and electrically check all the wiring connections and components individually for continuity, insulation and resistance. Starting with the motor and heater.

    December 28, 2013 at 2:20 pm #406792
    bill0606
    Participant

    Re: HOTPOINT WT960

    Hi I have tried it without any load and it filled up ok but then went to F20 then drained down again

    December 28, 2013 at 3:14 pm #406793
    iadom
    Moderator

    Re: HOTPOINT WT960

    F20 is not a recognised error code so you are still back to this,

    You have to remove the mains plug and visually and electrically check all the wiring connections and components individually for continuity, insulation and resistance. Starting with the motor and heater.

    H20 is supposed to be a filling fault code but often showed up when the machine was filling correctly.

    You have to love the cheap, unreliable electronics that Indesit use. 😥

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.